In a heavy calcium carbonate (GCC) sand and powder project, raw-material whiteness is a primary process-selection criterion. High-white and low-white limestone should not be forced into one standardized production route because the downstream product specifications and economic value are different.

Route 1: High-Whiteness Limestone for Sand and Putty Powder

Limestone that consistently meets the whiteness requirement for putty products can be processed through an integrated sand-and-powder production unit. A representative product split is 60% calcium sand and 40% powder.

The calcium sand fraction can be supplied to engineered stone, permeable brick, floor-aggregate and specialty mortar applications. The powder fraction can target 120-325 mesh putty powder, where whiteness, fineness and batch consistency are important to finished-product quality.

This integrated route extracts more value from each tonne of qualified ore because both the aggregate and powder outputs become saleable products. The actual split and product specifications should be confirmed from quarry test data, market demand and the operating basis of the selected line.

Route 2: Low-Whiteness Limestone for Aggregate and Tail-Powder Use

If limestone cannot meet putty-powder whiteness requirements, an integrated sand-and-powder unit may create an unsaleable powder fraction. A differentiated aggregate route is then more appropriate.

Dedicated sand-making equipment can produce calcium carbonate aggregate while limiting generated tail powder to no more than approximately 20% of output. A small Ring Roller Mill can then process this tail fraction into fine powder for desulfurization.

Desulfurization-grade heavy calcium powder generally does not require the same whiteness level as putty products, making this route a practical way to use lower-brightness material and reduce rejected process fines. The Ring Roller Mill can support controlled production across 120-2500 mesh, with the final particle-size distribution aligned to the buyer's desulfurization process.

Why One Standardized Route Is Not Enough

Using a conventional sand route for high-white limestone may leave high-value fine-powder potential undeveloped. Conversely, forcing low-white limestone through a sand-and-powder route can create powder that fails the intended whiteness standard and cannot earn a suitable price.

  • Test limestone whiteness and consistency across representative quarry batches.
  • Confirm target markets for calcium sand, putty powder and desulfurization powder.
  • Define allowable tail-powder generation and the value of each finished fraction.
  • Match the Ring Roller Mill capacity and fineness range to the actual powder product.
  • Review site layout, utilities and material handling as part of the complete line.
Selection principle: use high-white limestone for a 6:4 calcium-sand and putty-powder product mix. For low-white limestone, control tail-powder generation in the aggregate circuit and use a small Ring Roller Mill to convert suitable tail powder into desulfurization-grade heavy calcium powder.